Denton Vacuum
DV 502 A Vacuum
Provisional entry — research in progress
This page was generated automatically from cited public sources and hasn't completed the full research pass yet. Every specification shown carries its source; more detail is added as research completes.
The Denton Vacuum DV 502 A Vacuum is a vacuum evaporator. The Denton Vacuum DV 502 A Vacuum has a 12-inch diameter by 12-inch-high bell jar with an implosion guard.[1][2]
What it is
Where it fits in the process flow
General reference — not yet source-verifiedVacuum evaporation sits in the thin-film deposition portion of a process flow. Vacuum evaporators are commonly used after substrate preparation and before later patterning, lift-off, inspection, or electrical characterization steps. Vacuum evaporators can support process modules in research, pilot-line, and specialty fabrication environments where deposited films are part of device build sequences.
Applications
General reference — not yet source-verifiedVacuum evaporators are used to deposit thin films for metallization, contact formation, reflective coatings, and other surface layers where directional vapor transport is useful. Vacuum evaporators are also used for sample preparation and for laboratory or small-scale production work involving patterned films or blanket coatings.
What do the numbers mean?
Vacuum & pumping2
Configuration & options3
- 12” diameter x 12” H bell jar with implosion guard[2]
What does it need to run?
Site utility requirements, footprint, and infrastructure needed to install and operate this tool. Sourced from public records.
Where are the manuals?
Generated from public-source data on file. Enter your email to access — nothing is published; details are routed privately.
Not publicly documented
Field notes
No research found yet — worked with this tool? Share what you know.
Frequently asked questions
Not publicly documented
The following facts about the DV 502 A Vacuum are absent from this record as of this revision. First-hand knowledge or a citation closes a gap; every submission is reviewed before publication.
No publicly documented production dates or lifecycle milestones (introduction, end of production, EOL) for the DV 502 A Vacuum are on record.
Answerable by: OEM historical records or a trade-press announcement
No publicly documented variants, configuration options, or revision breakpoints of the DV 502 A Vacuum are on record.
Answerable by: an OEM product catalog or an engineer who ordered or specified the tool
The control-system platform and OS era of the DV 502 A Vacuum are not on record.
Answerable by: an engineer who operated it or OEM installation records
No publicly documented failure modes or field errata for the DV 502 A Vacuum are on record.
Answerable by: a field service engineer, process engineer, or maintenance technician
The process node or technology generation of the DV 502 A Vacuum is not on record.
Answerable by: an OEM datasheet or a fab qualification report
No research found yet — worked with this tool? Share what you know.
Sources & citations
Sources (2)Every fact above is drawn from these public sources
- [1]waferpedia.com — waferpedia.comwaferpedia.com
- [2]inventory listing
Last updated Oct 15, 2026.
Compare with similar tools
View all →
The Applied Materials 0010-13622 is an RF match unit intended for PVD (Physical Vapor Deposition) described as a High Efficiency HE RF Match-Bias.
The Applied Materials 0020 12458 Part is an insulator, side match component for the Hdp-Cvd Ultima Plus system.